NCR Data

Displaying 21 - 21 of 21

Link to Single Entry Incident No. Incident Date Item Part No. Item Part Description Quantity  Drawing No. JO NO. PO/SO. NO. GRN/OR/CR No. Operation Created By Created Date Title Incident Description  Standard Reference Type Supplier / Customer Name Disposition Justification  Category  Root Cause  Correction Action Correction Action Date Correction Action Owner Corrective Action Corrective Action Owner Corrective Action Date Preventive Action Preventive Action Owner Preventive Action Date Effectiveness Effectiveness Evidence Closure Date Upload Document Status
View DetailsNCR-2024-0006506/19/2024CSNDX288F043

PORTED SLEEVE FOR NON ELASTOMERIC, SLIDING SLEEVE DOWN TO OPEN MATERIAL : AISI 4140, 18-22 HRC OR EQ. TO L-80

0CSNDX288F043J2405-0083Not MentionedNot MentionedCNC TURNING PROCESS- 05 & 06QC06/19/2024NCR-24-0022 (Inprocess inspection)

1] Thread pitch dia is more then required pitch dia.required pitch dia is 96.83496 to 97.00006 mm and observed pitch dia 97.25mm.also there is thread cut observed due t5o power cut. 2] Groove position is shift 5.15mm on upward direction. required groove distance from face is 61.97mm and observed 56.97mm.photo's is also attached.

Not MentionedNot MentionedIn-house
  • Upload Document
  • Upload Document
  • Upload Document
  • Upload Document
  • Upload Document
Link to Single Entry Incident No. Incident Date Item Part No. Item Part Description Quantity  Drawing No. JO NO. PO/SO. NO. GRN/OR/CR No. Operation Created By Created Date Title Incident Description  Standard Reference Type Supplier / Customer Name Disposition Justification  Category  Root Cause  Correction Action Correction Action Date Correction Action Owner Corrective Action Corrective Action Owner Corrective Action Date Preventive Action Preventive Action Owner Preventive Action Date Effectiveness Effectiveness Evidence Closure Date Upload Document Status